1980 Phillips / Technidrill BTA Ejector Type Deep Hole Drilling Machine #6698 #2

2” X 126” Phillips / Technidrill BTA Ejector Type Deep Hole Drilling Machine

SPECIFICATIONS:

Drilling Diameter, Maximum 4”

Drilling Depth, Maximum 126”

Chuck 15.5” 3-Jaw

Hole Thru 5.25”

Feed Rate .5 to 12 IPM

Swing Over Ways 20”

Spindle Speeds Variable (Reliance DC VS Drive)

Spindle Horsepower 40 HP

High Pressure Coolant Pump 10 HP

Electrics 3/60/480V

Approx. Drill Dimensions 17’ x 4’ x 6’8” Height

Approx. Coolant System Dimensions 11’ x 8'4" x 8’ Height

EQUIPPED WITH:

The Drill is Currently Set-Up on a 15’ Base. The 40 HP Drill Head has a 10’ Travel with a Chip Box / Whip Guide. There is No Extension Table for the Work. The Drill is Currently Set-Up Using a Portion of the Stroke Capacity. There is a Work Support Carriage with a 12” 3-Jaw Chuck with 4” Thru Hole, Pressure Head, and Enerpac Hydraulic Clamping System. The Work Carrier Presently has 52” Travel on the Bedway with a Rack & Pinion Handwheel for Set-Up Positioning.

Operators Control Station with Spindle Pressure / Drill Monitor Load Meter. Spindle RPM Display. Spindle Variable Speed Controller. Feed IPM Thumb Wheel Selector. Manual and Automatic Operation Controls. Manual Operation Controls for Spindle Run. Coolant. Rapid Advance. Forward Feed, Retract, E-Stop, and Emergency Retract.

High-Pressure Coolant Filtration System with 5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it Through Filters into the Clean Coolant Top Tank. Micron Polishing Filtration with (4) Disposable Cartridge Type Filters. 10 HP Grundfos High-Pressure Coolant Pump.

Approximately (12) 60” BTA Drill Tubes with an ID Range from 1” to 2”. Tube Storage Rack. Air-Oil Mist Lubrication to the Spindle. Automatic Way Lubrication System. Chip Conveyor. Coolant Kooler Chiller. Manuals and Drawings.